Network Access & Telecommunications Equipment - RAD Data Communications
Home  |  Contact Us  |  Site Map  |  
search:

   GO
InfoCenter

Infocenter

 

Application Notes

 
Infocenter
  • White Papers
  • Case Studies
  • Application Notes
  • Brochures
  • Presentations
  • Audio Presentations
  • Data Sheets
  • Technology 101
  • End User Warranty
  • Performance Guarantee
  • Telecommunications Standards
  • Third Party Certified Solutions

    Connect Ethernet and E1/T1 Circuits between Two Sites Using Broadband Wireless

     Typical Users
    - Multi-location or campus-environment organizations
    - Carriers and service providers
    - Cellular operators
    - Government agencies or NGOs
    - Universities and school districts
     Typical Applications
    - Remote site connectivity of buildings, campuses, rural areas
    - Cellular TDM and Ethernet/IP traffic backhauling
    - Broadband wireless Last Mile where fiber cables are not available
    - Temporary or emergency site connectivity for special events, construction sites
    - Backup for terrestrial lines or for disaster recovery
    - Wi-Fi hot spot backhauling
    Many organizations need to connect voice and LAN traffic between offices in different buildings or sites, in simple point-to-point applications. Yet with the limited copper or fiber infrastructure in many areas, this may be very expensive if possible at all. Wireless transmission enables them to save the cost of expensive leased lines while eliminating the service provider’s need for deploying fiber, thereby enabling rapid deployment of E1/T1 and Ethernet links at a fraction of the cost.

    High Performance of E1/T1 and Ethernet over Radio

    RAD’s AirMux-200 enables the user to connect Ethernet and E1/T1 circuits between two distant sites over broadband wireless. The AirMux-200 supports a radio air interface bandwidth of up to 48 Mbps, yielding a full duplex throughput of up to 18 Mbps for user traffic. This means the user can transport up to four E1/T1 voice circuits and have ample bandwidth remaining for 10/100BaseT Ethernet traffic.

    Rapid Return on Investment

    The AirMux-200 pays for itself in no time by eliminating multiple leased line connections between buildings or the expense of laying fiber in the ground. Compared to just the monthly rental cost of leased lines, the AirMux-200 will provide ROI within a few months.
    Related Links
     Products
    AirMux-200
    What makes the AirMux-200 ideal for rapid and easy connection of Ethernet and E1/T1 circuits between two sites or buildings?
    Features Benefits
    Best price/performance in the industry Fast ROI versus leased lines

    1, 2 or 4 x E1/T1 ports,

    1 or 2 Ethernet ports

    		 Connection of all voice and data by a single compact device

    Air interface bandwidth of up to

    48 Mbps, yielding a full duplex payload of up to 18 Mbps

    High throughput, enough for up to

    4 x E1/T1 and Ethernet traffic

    Alignment tools and installation wizard Fast and easy deployment, cuts installation costs
    Range up to 80 km/50 miles* Extension of services to rural or remote regions

    • High link availability

    • E1/T1 latency less then 8 msec

    • Ethernet latency less then 3 msec

    • BER < 1e-11 @ sensitivity threshold

    		 Carrier-class performance
    RADview™ SNMP fault management Hundreds of links and access devices can be centrally managed from a single SNMP fault management application
    * Maximum transmission range over wireless is a function of the selected transmission rate, the services transported and the type of antenna used.
          		 
      |  legal  |  tell a friend  |  print page  |  (c) 2008 RAD Data Communications, Ltd.
     Products    Solutions    About Us    News    InfoCenter    Support    Where to Buy